Lock and Load: The Reassembled Machinist Guide

[valsemiel]

Anyone have any tips for a new MCH in A4S? We had our Ninja go Machinist to circumvent possible issues with 3 melee so he is still adjusting to the class.

Across 13 pulls spanning 50 minutes, our DPS looked roughly like this: Monk: 1277, Dragoon: 1169, Black Mage: 998, Warrior: 826, Machinist: 821, Paladin: 672, Scholar: 367, White Mage: 152.

He is i198 with this gearset: http://ffxiv.ariyala.com/RX4K

Any feedback will be greatly appreciated. Thanks!

[Griffeth]

Anyone have any tips for a new MCH in A4S? We had our Ninja go Machinist to circumvent possible issues with 3 melee so he is still adjusting to the class.

Across 13 pulls spanning 50 minutes, our DPS looked roughly like this: Monk: 1277, Dragoon: 1169, Black Mage: 998, Warrior: 826, Machinist: 821, Paladin: 672, Scholar: 367, White Mage: 152.

He is i198 with this gearset: http://ffxiv.ariyala.com/RX4K

Any feedback will be greatly appreciated. Thanks!

I am guessing you are pulling those numbers from logs? If so I would check the MCH uptime and if he is being pulled into the containment room as that would lower his damage and/or remove him from your logging due to possible range issues (not on a4 yet so not sure)

[Yellowskin]

Anyone have any tips for a new MCH in A4S? We had our Ninja go Machinist to circumvent possible issues with 3 melee so he is still adjusting to the class.

Across 13 pulls spanning 50 minutes, our DPS looked roughly like this: Monk: 1277, Dragoon: 1169, Black Mage: 998, Warrior: 826, Machinist: 821, Paladin: 672, Scholar: 367, White Mage: 152.

He is i198 with this gearset: http://ffxiv.ariyala.com/RX4K

Any feedback will be greatly appreciated. Thanks!

This might be a stupid question but does he know the right rotation yet? if not just show him, to this thread and make him also watch the rotation video.