Adding/Removing Cross-Abilities via Macro possible?

Hi there,

any way to enable/disable cross abilities via macro commands?

....with the new high level crafting recipes it would be very useful to swap abilities at your disposal when dealing with different types of crafts.
thx.

What would be the benefit of it (apart of saving a few seconds)? You can't change the abilities mid craft anyway ...

Quote:

---

Originally Posted by HEC

What would be the benefit of it (apart of saving a few seconds)? You can't change the abilities mid craft anyway ...

---

I have 3 or 4 different rotations based on type or recipe that I need to craft; some need Ingenuity some Ingenuity II, some WN some WNII, some MM2 some Manipulation, etc...

Nothing is worst than having every single time check your abilities and swap them accordingly. While of course respecting your opinion, I think this feature would be much more useful than a lot of other stuff asked for, to be honest.

This would also be quite useful for some other classes, too. There are times where you have an open slot or two for x-class abilities. For example, if I'm offtanking on WAR, I prefer to have Mantra set instead of Flash (especially in fights where you aren't managing multiple targets). Often, I'll set Mantra but forget to go back to Flash for normal dungeons, and then I'm left with only Overpower. I like to balance between that and Flash in these cases. Similarly, I might not always decide to use Awareness (I mostly use it on high damaging targets, where a crit can potentially kill you - but in weaker fights, even a crit isn't going to do much).