PS3 & Fates

[Whizawk]

When you're at the popular Fate event (specifically in Coerthas) there are so many players there, which causes the PS3 to not be able draw up the monsters that you want to attack.
All that is visible are companions and minions and mounts.

How would it be beneficial for the game to prioritise the visual feedback of the these things rather than the monster that is current attacking you; you want to attack? Let alone them being more important than drawing up the players!

I would much rather see no other players (just my party) and no mounts/minions/companions and just see the monster I am attacking alone, because that is the most important! Especially when you're under attack and you cannot fight back!

Please address this issue.

[surrel]

You can filter out targeting other players/minions and even your party members. It helps a lot in FATEs. However, the issue I still run into a lot is that it won't target monsters closest to you and sometimes you'll still have to do a bit of scrolling but at least you only target monsters and not everyone and their mom.

[Whizawk]

This isn't about targeting.
Graphically there is an issue on both PC & PS3 where in the presence of a huge amount of players (FATE) monsters just simply wont appear and cannot be targeted - they're not there.

This is irritant when the monster is attacking you and you can't fight back.

Though a Dev on the forum said that they're looking at ways to address this issue.

[Arriverderci]

You can filter out targeting other players/minions and even your party members. It helps a lot in FATEs. However, the issue I still run into a lot is that it won't target monsters closest to you and sometimes you'll still have to do a bit of scrolling but at least you only target monsters and not everyone and their mom.

It's not that, well...even though it's a pain in the ass targeting as a healer too, and confuses me to hell.
Shit loads slow and you can't see the enemies.
But they are trying to figure what to do about it. It's a PS3 and PC problem.
Look @ the Dev Tracker and see.