Off Topic Discussion Megathread

[Local_Custard]

I was working on making a bell in class- thought to share the process.

I started by making a template. Created in ProCreate. I printed it out to be a little less than 4" x 4"


next I begin sawing it out. I thought segmenting the sawing would make things easier. By the very least I could pick one of eight segments to work on and take breaks if needed.


once cut out I can work on drilling the hole. I beveled it using a bur. I then proceeded to begin filing.


sanded up to 1K grit.


I also went ahead and made two halves of a brass bead (the bell is made of copper). I included a notch for each one so that it will not explode while I solder it. It'll be the charm that goes inside.


This is as far I could get before I had to go home and eat. I plan to make more bells- right now this is a prototype to see how small it'll end up.