Thread: Summoner: Necrologos / Skyfire Leve Issue

Hello, I'm (attempting) to work on my Relic Reborn quests, but I'm stuck on a Leve in Book of Skyfire I.

The Leve is Necrologos: Pale Oblation. Not sure if I'm doing something wrong, or if the quest is borked.

As near as I can tell, what's supposed to happen is that I run around a small area and grab five pages of the magic book, then I guess a demon appears for me to fight, or something.

What is actually happening is a few Hungry Dreadwolves appear. They have the little Leve symbol above them. Killing them doesn't seem to do anything. The don't drop any pages.

I've reset the quest several times; only one time did I find a book page. It was in a chest. Out of maybe five reset attempts, that is the only time a page has appeared.

Four green circles appear outside Camp Bluefrog, which suggest that the pages should be there. The circles persist after I kill the Hungry Dreadwolves.

Does anyone have any insight or suggestions? Is this a known issue, or is there something (probably obvious) that I'm not doing?

I can't proceed with my Relic Reborn quests until I get past this one Leve...

I knew the leve was working properly(unless it had broken in the last month or so), having done it several time before, but couldnt remember what it was you had to do. So i logged in, and just finished it. The hungry wolves are spawned by the quest, but not really there for anything but to be in the way. What you are looking for are pieces of parchment on the ground in those green circle areas. Some of them will spawn additional mobs, others will just count as pages. Once you collect 5 pages, the "boss mob"(ie slightly bigger piece of nothing) spawns and you finish the leve by downing him. The wolves can be ignored if they dont see you, or killed for small extra bits of exp.

Thanks Frizze. For some reason, no pages are spawning for me... do you recall what form they took? Are they obvious, or very hidden? I've searched all throughout the circles and only once found a single chest that contained a page.

Check your nameplate settings to see if you have disabled nameplates on objects. They're a lot easier both to spot and to interact with if the nameplate is there.