calling all MCH players

[XgungraveX]

after getting mch as my first lvl 70 job in SB i wasn't happy with the dmg i was putting out so i decided to shelved the job. atm and leveled sam and drk to get them geared out my sam is ilvl 313 and drk ilvl 308 which at that point i dont need any tomes of verity and i got capped today so i decided to give a shot mch again with some 310 gear i have the weapon atm too. my question is this, anyone know a good rotation or guide i can maybe follow?

[Lastelli]

I think Aiurily's videos are very helpful.
Basically you start with a Wildfire and you blow all your ogcd abilities and repeat every 60 seconds. Overheat at every odd numbered Wildfire after the first one. Use Cooldown when needed to stay in the 50-90 heat range. This is the core of the job, pretty straightforward as long as you don't mess up and overheat when you shouldn't.

[XgungraveX]

I think Aiurily's videos are very helpful.
Basically you start with a Wildfire and you blow all your ogcd abilities and repeat every 60 seconds. Overheat at every odd numbered Wildfire after the first one. Use Cooldown when needed to stay in the 50-90 heat range. This is the core of the job, pretty straightforward as long as you don't mess up and overheat when you shouldn't.

any benfits letting your barrel overheat and when to use rook over load?

[KaiSunstrider]

any benfits letting your barrel overheat and when to use rook over load?

You get a damage bonus while overheated. So you wanna do it at the proper time when you have your cds ready to get you back up to 50 quick

[XgungraveX]

You get a damage bonus while overheated. So you wanna do it at the proper time when you have your cds ready to get you back up to 50 quick

so overheat dump all dmg into wildfire then barrel stabilizer back to 50 after burst?

[Lastelli]

so overheat dump all dmg into wildfire then barrel stabilizer back to 50 after burst?

Pretty much, yes. There are exceptions, like when a boss is going to jump you can overheat even if stabilizer isn't ready (possibly during a last wildfire before the jump) and use flamethrower when the boss is away to go back to 50 heat but in general it's just as you've written.

[XgungraveX]

Pretty much, yes. There are exceptions, like when a boss is going to jump you can overheat even if stabilizer isn't ready (possibly during a last wildfire before the jump) and use flamethrower when the boss is away to go back to 50 heat but in general it's just as you've written.

i try this as my barrel was over heating i wasnt able to get through my rotation within the window frame before it falls off then i complete the rotation with normal dmg instead and the wild fire goes off for 9k-10k dmg.