Shots Fired: A Machinist Guide

[Lavieh]

Not sure if this is what you are looking for Dervy but I put my oGCD rotation on a spreadsheet and looked for anytime that I would optimally hold a GCD:

Blood for blood:

Used @ -3 seconds before Pull
Used @ 90 Seconds

Hawk Eyes:
Used @-2.5 seconds before pull
Used @92.5 seconds

Hypercharge
Used @-2 seconds before pull

Raging Strikes
Used@-1.5 seconds before pull

Reload
@2.5
@62.5

Wildfire
@5
@95

Reassembled
@7.5
@67.5

Ricochet
@7.5
@70

Gauss Round
@10
@30
@50
@72.5
@97.5
@117.5


Rapid Fire
@10
@100


Graze

@10
@35
@60
@100

Blank
@13
@43
@75
@105.5

Quick Reload
@14.5
@42.5
@77.5
@112.5

That is pretty much my GCD timetable for the first 2 minutes. Certain GCD's are pushed back to prevent GCD bloat.

What Aiuri is talking about is that if we get a Slug shot or clean shot proc we can insta cast those and we can squeeze in 2x oGCD's per GCD. After the initial opener I just assume one oGCD per GCD.

[Dervy]

A network parse would be better as it's just a simple copy & paste into my excel spreadsheet, but I guess I could work with that.

[Odowla]

A network parse would be better as it's just a simple copy & paste into my excel spreadsheet, but I guess I could work with that.

how do i send it to you, i'll just grab the ony from my video (and a couple of other tries too)

[Dervy]

Uhhhhhh, grab it, upload it to filedropper.com/google drive/mega.co.nz and either inbox me, or post link here. If you can't isolate the parses log, meeh it's fine. Just send me the whole thing and I'll sift through it.

[Odowla]

Sent it to you in a reddit pm. At least, that log is what i think you're looking for. If not I can do the whole .act file

[Haxetc]

I know this has been mentioned elsewhere but I just noticed I wasn't getting all my WF damage during A3S. The flying text showed up and everything. I just didn't get the damage parsed at all for 3 of the 5 WF's in one instance.

[Odowla]

I know this has been mentioned elsewhere but I just noticed I wasn't getting all my WF damage during A3S. The flying text showed up and everything. I just didn't get the damage parsed at all for 3 of the 5 WF's in one instance.

ACT doesnt pick them all up for some reason.. sometimes i just "burst" 1600 with a 9k wildfire and i'm like wtf.

[Haxetc]

ACT doesnt pick them all up for some reason.. sometimes i just "burst" 1600 with a 9k wildfire and i'm like wtf.

Yea, I noticed it in A3S when I had a 10k wildfire and my burst DPS was lower than I'd ever seen it lol. I almost just wiped the group to restart.

[Odowla]

Yea, I noticed it in A3S when I had a 10k wildfire and my burst DPS was lower than I'd ever seen it lol. I almost just wiped the group to restart.

yeah you really notice it with the BIG ones that make everyone go WTF is that, but you see your dps and its <2k. Probably just because its registered as a DoT tick



Edit
finally got a run (and cleared) where iIt displayed all of my wildfires


All in All, MCH is pretty good for this fight but it takes forever to learn where to put your turret in the last phase so you can hit the raid with TP song and have it not be cleaved - I think BRD has the advantage on this.

[Lavieh]

Yea, I noticed it in A3S when I had a 10k wildfire and my burst DPS was lower than I'd ever seen it lol. I almost just wiped the group to restart.

When ACT does this, the Wildfire will still be parsed and it should show up under "Unknown" iirc.