Connecting the DoTs: A Summoner Guide

[Judge_Xero]

Waiting for that kind of situation is theoretically dps loss. You wanna use it every time skill is out from the cd. I have not calculated what would be most wise way use this kind of ability since it is not even important cause anything is not confirmed, but i think you should use it after next what ever dot is gonna fall of from your target after skill drop out from the cooldown so you can use it often as possible.

I think for any type of single target rotation, if 3D is on a CD and depending on which CD, that you would want to use it:
A: With Raging Strikes in this order - Hard Cast Dots B2, M, B and then use 3D for a full Refresh when Bio drops to extend your buffed dots.

Like if it's no Aetherflow, it's gonna be amazing to use around just generally especially when like you have two DoTs at like lets say 5 seconds and another at like 1 second left fairly sure if you use it in a moment like that, it would be a DPS gain.

Which is essentially this, as you would have this {B2 13s M 9s B 5} before you Refresh. Since if 3D is free, then why not while you're buffed, since it's higher Potency/s.
----------------------------------------------------------------------

Hard Casting DoTs VS 3D - If it's around a 235 Potency Loss (75 Dot Setup + 2 X Ruin) each time it's on CD and you don't use it you could pre-determine if it would be ideal to hold it for an AOE situation.

3D + Bane would be a 75 Potency Gain per target + Ruins. So withholding 3D 1 time in an effort to 3D Bane 2 or more Targets would be a DPS increase IMO.

----------------------------------------------------------------------

This would really streamline the decision making for SMN if that is the case.