Hear me out Square, Wall mounted Spacers

Small cylindrical wall mounted items of various sizes, that can have wall mounted items to it. Like, currently how it is
[]()
[]()H
[]()H
[]()H
[]()

[] = Wall ()=Furnishing H= Picture Frame / 00=Spacer

If items wall items are too close to all they tend to "stick" to it. Like,
[]()
[]H)
[]H)
[]H)
[]()

Can we get a spacer saucer or cylinder (of various sizes) So I can get my painting to stand out infront of my wall furnishing and not stick to the wall behind the furnishing?

[]()
[]() H
[]00H
[]() H
[]()


Edit:If they made a floor version, that might half the inputs needed to get it up there. Ya know for those who drive "housing stick shift", it would be a very helpful.

While it would be nice to have object spacers as you described, that would then take up a slot in your furnishings totals for an effect you can currently achieve by glitching.
As in, set up a partition (or some object that can hold other objects, like a table or such also), put objects on it in the position you want the objects to be in in 3D space, then glitch move & remove the partition and the left over object are now "floating" where they were.
See my FC estate plot on Faerie - Shirogane Ward 22 Plot 7, in the entrance hall with the torches and at the start of the museum next to the housing NPC where the guest book is, for some examples of object-float-glitching.
More info: https://hgxiv.com/glitch-guide/

A better solution than what you described would be to allow for 3D placement of basically everything, assuming the housing engine can handle that.
That way, you do not have to use up an extra furnishings slot to achieve a stand-off of a wall mounted item.

Quote:

---

Originally Posted by Mireille_Bouquet

While it would be nice to have object spacers as you described, that would then take up a slot in your furnishings totals for an effect you can currently achieve by glitching.
As in, set up a partition (or some object that can hold other objects, like a table or such also), put objects on it in the position you want the objects to be in in 3D space, then glitch move & remove the partition and the left over object are now "floating" where they were.
See my FC estate plot on Faerie - Shirogane Ward 22 Plot 7, in the entrance hall with the torches and at the start of the museum next to the housing NPC where the guest book is, for some examples of object-float-glitching.
More info: https://hgxiv.com/glitch-guide/

A better solution than what you described would be to allow for 3D placement of basically everything, assuming the housing engine can handle that.
That way, you do not have to use up an extra furnishings slot to achieve a stand-off of a wall mounted item.

---

The setup you have doesn't create the conditions for the issue I want the item added for.

[]()
[]() H
[]() H
[]() H
[]()

The setup in the front you describe doesnt have a wall close enough to interact with. So it'll float just fine. Its when you move HHH near a wall you'll notice it will always attach itself. And if u have a furnishing infront of the wall it'll clip itself inside the items onto the wall behind it.

The solution I'm asking for is basically a item they can create rather then asking them to rework an entire system. A smaller ask.

Here's a direct example