I just did Halatali lvl 20 dungeon as a lvl 44 warrior, but my beast gauge was replaced by the old enmity gauge and i couldn't use any of my warrior beast mode moves. After the dungeon it was a normal beast gauge again.
Anyone know why that is?
Printable View
I just did Halatali lvl 20 dungeon as a lvl 44 warrior, but my beast gauge was replaced by the old enmity gauge and i couldn't use any of my warrior beast mode moves. After the dungeon it was a normal beast gauge again.
Anyone know why that is?
Assuming you weren't running Halatali unsynced, your level would have gotten synced down to the point of not having any abilities that use the beast gauge. As far as I know, the beast gauge bar doesn't show up until you're able to use abilities that use it.
You don't get any Beast Gauge using skills till 30 I think? So being sync'd down under that removes the Beast Gauge.
You don't get anything Beast Gauge related until lvl 30 I believe, since you were synced down to 20 you didn't have Beast Gauge unlocked so it was just the normal tank stance display.
That makes sense, next time i'll remove that stone so my hotbar goes back to marauder
That would work (but isn't necessary) if you're explicitly selecting a below 30 dungeon, but if you do leveling roulette, it could put you in either a below 30 or above 30 dungeon, so you'll need your job stone then. You can't change jobs in a dungeon or enter with a different one than you queued with.
And there will be later points in which your warrior rotation will change significantly when you get an important new skill, and none of the others after 30 give you a job change with a new set of hotbars. Level sync can change you to any previous level depending on the content you're doing, so you'll need to get used to using a subset of your hotbar skills depending on where you are.