I've been struggling to set this up for my paissa mansion behind the house. The stump+arc hasn't been doing it for me. Will try this new way! Different house skin but same idea.
Printable View
I've been struggling to set this up for my paissa mansion behind the house. The stump+arc hasn't been doing it for me. Will try this new way! Different house skin but same idea.
has anyone perfected this for a carbuncle house? i've tried but unsuccessful so far
Thank you for this! I finally set up an elevator for my FC's house, and then a week later we switched to the Shirogane exterior and it broke the elevator.
Side note: Is it possible to jump onto the Shirogane balcony? With every other balcony we've had, I've been able to go from the Chocobo Stables to a Sylphic Lamp Tree, and then onto the balcony, but it seems like this one is just too high to jump onto normally.
Thanks for the advice, I too finally got my 'elevator' up and working.
Theoretically, it should be possible to setup the warp machine in any housing so long they:
A. Have a roof at or lower than the height of the Large Shirogane Castle Wall and/or
B. The roof overlaps the wall horizontally at least a little (like 2, 3 lalafell-width)
With that said, it does take quite a bit of trial and error to set it up, so good luck! :3
Congrats! XD
I hate to be that guy, but... You talk about this being 'precise' but then provide probably the worst possible angles in screen shots with probably the lowest possible quality.
Would it be possible to perhaps be more clear with the precision process that is placing this nonsense?
Fun fact, plot 30/60 in Shirogane has a cliff behind it that allows you to just jump on the castle roof.
However, I would kill to have an elevator for our balcony. How has SE not put a portal on that balcony door yet?!
I tried to do the method as TC suggested, but it was working for a bit and then its not working anymore. ( tried the side one)
Need a better confirmation to see if it works x_X