error 1160

[langy]

hi, i was in abyssea earlier and /sea etc was taking a long time to load up... after i had finished i warped out, the loading screen then was on for over 5 minutes so i just closed ffxi and tried to just login again... anyway i then got error code POL-1160, i googled it and everyone who had posted anything about this had been getting it due to a maintenance... i also read somewhere that should try to uninstall playonline and then reinstall it so i tried this.

now that its reinstalled im still getting the exact same error, ive had this problem now for the past 10 hours and ive also reset router etc.

thanks for any help. muchly appreciated

[SE_Chris]

We would like to apologize for the problems you are experiencing, and we can offer a few suggestions to try to assist you in resolving this problem.

Suggestions:
1. Check to make sure you have properly configured or turned off any of the following: Routers, Proxy Servers, NAT Servers, Internet Connection Sharing services.
2. If you are using any kind of software/hardware Internet Sharing service/device the following ports need INCOMING access to your PC: TCP 1024 - 65535, UDP 53, and 50000 - 65535. Also, check to make sure that the ports mentioned are not blocked by your ISP for INCOMING access. Proper configuration of any of the above items mentioned should be done by following the instructions in the software/hardware manual or calling the manufacturer's technical support.
3. If you are using a router, and have configured that router for port forwarding, temporarily bypass that router and connect directly to the modem.

Please take note of the following:
• Proxy servers, and satellite connections are not supported and do not work correctly with FINAL FANTASY XI.
• Your router may require that you use a PC to configure your network settings. For more information about how to configure your network settings, please refer to the instruction manual that came with your router or contact the manufacturer directly.
• If your Internet Service Provider (ISP) specifies a DNS server, you need to make sure to configure your settings to allow packets to pass through UDP Port 53 as well. For more information, please refer to the instruction manual for your router or the information provided by your ISP.