Pysto
05-22-2013, 10:10 PM
Was getting a tele from adouline to xarcabar with a friend and did get kicked out from game since then can't relog on both my characters getting error pol 0006 at start then 3100 or 3001 saying can't reach server and 1160 too when I can reach character page my main is in zone unknow what can I do?
Dalan
05-22-2013, 10:51 PM
Same for me unable to connect lobby server and such
Having this issue too. POL was very slow this morning. I finally got in, zoned to East Ronfaure [S], and d/ced. Can't get back on. This is on Carbuncle.
SE_Chris
05-23-2013, 07:04 AM
We would like to apologize for the problems you are experiencing, and we can offer a few suggestions to try to assist you in resolving this problem.
Suggestions:
1. Check to make sure you have properly configured or turned off any of the following: Routers, Proxy Servers, NAT Servers, Internet Connection Sharing services.
2. If you are using any kind of software/hardware Internet Sharing service/device the following ports need INCOMING access to your PC: TCP 1024 - 65535, UDP 53, and 50000 - 65535. Also, check to make sure that the ports mentioned are not blocked by your ISP for INCOMING access. Proper configuration of any of the above items mentioned should be done by following the instructions in the software/hardware manual or calling the manufacturer's technical support.
3. If you are using a router, and have configured that router for port forwarding, temporarily bypass that router and connect directly to the modem.
Please take note of the following:
• Proxy servers, and satellite connections are not supported and do not work correctly with FINAL FANTASY XI.
• Your router may require that you use a PC to configure your network settings. For more information about how to configure your network settings, please refer to the instruction manual that came with your router or contact the manufacturer directly.
• If your Internet Service Provider (ISP) specifies a DNS server, you need to make sure to configure your settings to allow packets to pass through UDP Port 53 as well. For more information, please refer to the instruction manual for your router or the information provided by your ISP.